---------------------------------------------------------- XDP4000X-List Digest Archive --- Total Messages Posted Mon 10/25/04: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 07:47 PM - Broken XDP-210??? (Carl Renaghan) 2. 08:58 PM - Re: Broken XDP-210??? (Bobby Braun) ________________________________ Message 1 _____________________________________ Time: 07:47:15 PM PST US From: Carl Renaghan Subject: XDP4000X-List: Broken XDP-210??? --> XDP4000X-List message posted by: Carl Renaghan I bought an XDP-210 from someone in the EliteCarAudio.com forums. When I hooked it up to my C90, the C90 does not power up. If I unhook it, the C90 comes back alive. I am using an Alpine bus cable (I am told its the same as Sonys). Any ideas? __________________________________ ________________________________ Message 2 _____________________________________ Time: 08:58:02 PM PST US From: "Bobby Braun" Subject: Re: XDP4000X-List: Broken XDP-210??? --> XDP4000X-List message posted by: "Bobby Braun" It could be a bad Unilink Cable. I had one go bad on my changer, and it affected the rest of the setup much like you're describing, so I'd try a new one of those first. Also, make sure that you don't have the remote output from the C90 feeding into the remote output of your 210EQ. My local dealers didn't realize that there was no need to give the processor a turn on signal, since it's fed through the Unilink cable. During an install, they hooked up both outputs to each other almost fried both my head and processor (smart guys). Other than that, the hookup of the 210EQ is pretty simple, and as long as you ruled out any other possible power/ground issues, if the above mentioned items don't help, you might have to look towards getting it repaired. Good luck. ----- Original Message ----- From: "Carl Renaghan" Subject: XDP4000X-List: Broken XDP-210??? > --> XDP4000X-List message posted by: Carl Renaghan > > I bought an XDP-210 from someone in the > EliteCarAudio.com forums. When I hooked it up to my > C90, the C90 does not power up. If I unhook it, the > C90 comes back alive. > > I am using an Alpine bus cable (I am told its the same > as Sonys). > > Any ideas? > > > __________________________________ >