Today's Message Index:
----------------------
1. 08:06 AM - Re: Help! C-90 faceplate emitting continuous tone? (Carl Renaghan)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Help! C-90 faceplate emitting continuous tone? |
--> XDP4000X-List message posted by: Carl Renaghan <orudus@yahoo.com>
I had this problem when I plugged in a dead XDP-210 to
my C90. If I unplugged the EQ, and reset teh C90, it
went away.
--- Paul Chambers <xdp4000x@lists.bod.org> wrote:
> --> XDP4000X-List message posted by: "Paul Chambers"
> <xdp4000x@lists.bod.org>
>
> My car has been sitting awhile, and the battery ran
> flat. I fully recharged
> it, but now when I turn on the ignition, the C-90's
> faceplate just emits a
> continuous tone and does not turn on the display.
> It's not inverter whine,
> but some sort of error signal. When I turn off the
> ignition, the tone stops,
> and after a few seconds I get the 'remove faceplace'
> two-tone reminder
> beeps, as normal.
>
> I pushed several of the faceplate buttons to see if
> that had any effect. The
> eject did, the faceplate dropped as normal. But it
> won't retract...
>
> Anyone know what's going on? How do I get it to
> behave itself again? Just
> when I'm about to sell the car too, darn it...
>
> Paul
>
>
>
> http://www.matronics.com/archives
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|