Yak-List Digest Archive

Fri 10/19/07


Total Messages Posted: 5



Today's Message Index:
----------------------
 
     1. 07:55 AM - Red Air FAll Fling III Cancelled (viperdoc)
     2. 12:37 PM - Looking for Yak 18T Radio Head (vectorwarbirds@aol.com)
     3. 02:23 PM - Re: Looking for Yak 18T Radio Head (N13472@aol.com)
     4. 04:23 PM - Newbie questions (Mike & Lyne Bourget)
     5. 05:35 PM - Re: Newbie questions (A. Dennis Savarese)
 
 
 


Message 1


  • INDEX
  • Back to Main INDEX
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 07:55:59 AM PST US
    From: "viperdoc" <viperdoc@mindspring.com>
    Subject: Red Air FAll Fling III Cancelled
    Attention All Prospective Red Air Fall Fling Participants It is CANCELLED Due to Weather and IP/FL availability For those just wanting to fly and practice, we are still planning on flying tomorrow from approx 0830 until. (Sat.). If you just want to come over, up, or down just to fly and eat some BBQ, show up tomorrow morning at 08A (Wetumpka). The prog is for the ceilings to start lifting around 1100 local with it being partly cloudy Fri afternoon and Clear Sat. with light winds. Blitz, do you want me to send the training folders back to you or to Shane Golden? Later, I'm going Bow Hunting! Doc


    Message 2


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 12:37:30 PM PST US
    Subject: Looking for Yak 18T Radio Head
    From: vectorwarbirds@aol.com
    Looking for Yak 18T radio head in good working order.? Thanks ________________________________________________________________________ Email and AIM finally together. You've gotta check out free AOL Mail! - http://mail.aol.com


    Message 3


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 02:23:59 PM PST US
    From: N13472@aol.com
    Subject: Re: Looking for Yak 18T Radio Head
    WHAT? you have gone over to the DARK side??????? Tom Elliott CJ-6 NX63727 Sandy Valley NV 3L2 702-723-1223


    Message 4


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 04:23:31 PM PST US
    From: "Mike & Lyne Bourget" <thebourgets@cia.com>
    Subject: Newbie questions
    Hi,, all Newbie from Ottawa, I'm a member of RPA and I've flown in "the dragon" with Dan Fortin. He convinced me <grin> to sell my RV8 project and I'm now actively looking for a CJ. I've found a couple I'm very interested and have a couple of questions. How concerned would you be about an engine with roughly 330 total time, that has had a hydro lock? It was professinonally repaired with a new piston, push rods etc. Also,, a comp on cyl # 2 is 68. Should I be concerned by this low a reading? It is on the housai. I'll have lots more questions, and any advice, words of wisdom are appreciated. Thanks Mike


    Message 5


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 05:35:57 PM PST US
    From: "A. Dennis Savarese" <dsavarese@elmore.rr.com>
    Subject: Re: Newbie questions
    Read the attached which discusses compressions. Dennis ----- Original Message ----- From: Mike & Lyne Bourget To: yak-list@matronics.com Sent: Friday, October 19, 2007 6:22 PM Subject: Yak-List: Newbie questions Hi,, all Newbie from Ottawa, I'm a member of RPA and I've flown in "the dragon" with Dan Fortin. He convinced me <grin> to sell my RV8 project and I'm now actively looking for a CJ. I've found a couple I'm very interested and have a couple of questions. How concerned would you be about an engine with roughly 330 total time, that has had a hydro lock? It was professinonally repaired with a new piston, push rods etc. Also,, a comp on cyl # 2 is 68. Should I be concerned by this low a reading? It is on the housai. I'll have lots more questions, and any advice, words of wisdom are appreciated. Thanks Mike




    Other Matronics Email List Services

  • Post A New Message
  •   yak-list@matronics.com
  • UN/SUBSCRIBE
  •   http://www.matronics.com/subscription
  • List FAQ
  •   http://www.matronics.com/FAQ/Yak-List.htm
  • Web Forum Interface To Lists
  •   http://forums.matronics.com
  • Matronics List Wiki
  •   http://wiki.matronics.com
  • 7-Day List Browse
  •   http://www.matronics.com/browse/yak-list
  • Browse Yak-List Digests
  •   http://www.matronics.com/digest/yak-list
  • Browse Other Lists
  •   http://www.matronics.com/browse
  • Live Online Chat!
  •   http://www.matronics.com/chat
  • Archive Downloading
  •   http://www.matronics.com/archives
  • Photo Share
  •   http://www.matronics.com/photoshare
  • Other Email Lists
  •   http://www.matronics.com/emaillists
  • Contributions
  •   http://www.matronics.com/contribution

    These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.

    -- Please support this service by making your Contribution today! --