Today's Message Index:
----------------------
1. 02:15 AM - Yak List: Heating (John Alber)
2. 12:30 PM - Re: Heating (Doug Sapp)
3. 12:58 PM - Re: Heating (Mark Davis)
4. 01:20 PM - Re: Heating (Doug Sapp)
5. 03:09 PM - Anybody seen Ernie? (Doug Sapp)
6. 05:12 PM - Email address (Doug Sapp)
7. 05:28 PM - Re: Email address (Doug Sapp)
8. 09:58 PM - Vynal stickers (Drew)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Yak List: Heating |
Dave,
I use a 125K BTU kerosene heater of the type available at
Tractor Supply.
John
Time: 05:45:18 PM PST US
From: Dave Laird <dave@davelaird.com>
Subject: Re: Yak-List: Heating
Hi John,
What kind of salamander do you use? Is it fueled by kerosene or
propane? Also, how many BTU's does it generate?
Dave Laird
N63536 1983 CJ6A "Betty"
Dallas (ADS)
John Alber
john@johnalber.com
314-259-2144
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Dave, John
You should be a bit careful about heating your prop hub as packed grease
will melt and flow out of place if it gets to hot, so proceed carefully.
IMHO
A Easy Heat on the oil cooler, another on the oil tank, foam in the cowl
cheeks and a full cowl blanket which covers the gills and all the way
around and under the cowl should get you by in a unheated hanger unless
the temps get severe. I am not talking about some old blanket your wife
lets you use, I'm talking about a fitted, made for the Yak/CJ cowl
insulated blanket. I have three or four in stock if you need one.
Doug
Dave Laird wrote:
>
> Hi John,
>
> What kind of salamander do you use? Is it fueled by kerosene or
> propane? Also, how many BTU's does it generate?
>
> Dave Laird
> N63536 1983 CJ6A "Betty"
> Dallas (ADS)
>
>
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Doug,
What's your opinion on leaving a small heat source such as 40-60W
light bulb all the time or is it preferable to just heat it up when it's
likely to be started?
Mark Davis
N44YK
----- Original Message -----
From: "Doug Sapp" <rvfltd@televar.com>
Sent: Friday, December 07, 2007 1:26 PM
Subject: Re: Yak-List: Heating
>
> Dave, John
> You should be a bit careful about heating your prop hub as packed grease
> will melt and flow out of place if it gets to hot, so proceed carefully.
>
> IMHO
> A Easy Heat on the oil cooler, another on the oil tank, foam in the cowl
> cheeks and a full cowl blanket which covers the gills and all the way
> around and under the cowl should get you by in a unheated hanger unless
> the temps get severe. I am not talking about some old blanket your wife
> lets you use, I'm talking about a fitted, made for the Yak/CJ cowl
> insulated blanket. I have three or four in stock if you need one.
>
> Doug
>
> Dave Laird wrote:
>
>>
>> Hi John,
>>
>> What kind of salamander do you use? Is it fueled by kerosene or
>> propane? Also, how many BTU's does it generate?
>>
>> Dave Laird
>> N63536 1983 CJ6A "Betty"
>> Dallas (ADS)
>>
>>
>>
>>
>>
>>
>>
>>
>>
>
>
>
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Mark,
Yes a cowl blanket and a bulb will do the job, but for safety sake use a
high impact bulk. I have not bought one in a while but used to get them
from the auto stores like Napa.
Best,
Doug
Mark Davis wrote:
>
> Doug,
> What's your opinion on leaving a small heat source such as 40-60W
> light bulb all the time or is it preferable to just heat it up when
> it's likely to be started?
>
> Mark Davis
> N44YK
>
> ----- Original Message ----- From: "Doug Sapp" <rvfltd@televar.com>
> To: <yak-list@matronics.com>
> Sent: Friday, December 07, 2007 1:26 PM
> Subject: Re: Yak-List: Heating
>
>
>>
>> Dave, John
>> You should be a bit careful about heating your prop hub as packed
>> grease will melt and flow out of place if it gets to hot, so proceed
>> carefully.
>>
>> IMHO
>> A Easy Heat on the oil cooler, another on the oil tank, foam in the
>> cowl cheeks and a full cowl blanket which covers the gills and all
>> the way around and under the cowl should get you by in a unheated
>> hanger unless the temps get severe. I am not talking about some old
>> blanket your wife lets you use, I'm talking about a fitted, made for
>> the Yak/CJ cowl insulated blanket. I have three or four in stock if
>> you need one.
>>
>> Doug
>>
>> Dave Laird wrote:
>>
>>>
>>> Hi John,
>>>
>>> What kind of salamander do you use? Is it fueled by kerosene or
>>> propane? Also, how many BTU's does it generate?
>>>
>>> Dave Laird
>>> N63536 1983 CJ6A "Betty"
>>> Dallas (ADS)
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>
>>
>>
>>
>>
>>
>
>
Message 5
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Anybody seen Ernie? |
Ernie Martinez Please give me a call @ 509-826-4610.
Doug
Message 6
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Listers and lurkers,
If your emails to my rvfltd@televar.com address have been kicked back as
spam please use my dougsappllc@gmail address. Several customers in AU
and NZ have reported that using the gmail address seems to solve the
problem.
Always yakin,
Doug Sapp
Message 7
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Email address |
Correction:
The back up address is dougsappllc@gmail.com (left off the .com in the
prev post)
sorry.
Doug
Doug Sapp wrote:
>
> Listers and lurkers,
> If your emails to my rvfltd@televar.com address have been kicked back
> as spam please use my dougsappllc@gmail address. Several customers in
> AU and NZ have reported that using the gmail address seems to solve
> the problem.
>
> Always yakin,
> Doug Sapp
>
>
Message 8
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Does anyone have the vector art for the canopy rescue arrows - or the vynal?
Also, the ICAO fuel placards would be nice.
Off list if able, thanks!
Drew
Looking for last minute shopping deals?
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|