Today's Message Index:
----------------------
1. 06:00 AM - Red Alert Winter 2009 (Russ)
2. 07:34 AM - Re: nose gear actuator mount... (doug sapp)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Red Alert Winter 2009 |
RPA, nice tribute to Forrest and Larry.
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: nose gear actuator mount... |
Bill and all:
On a CJ6 the nose gear actuator mounts to the airframe via the end cap which
has a bearing in it. Many of these caps are defective. We have Rockwell
tested many and have found some of them very soft. The soft ones tend to
become stretched out in a oblong manner, allowing the bearing to slop up and
down. We have a fix for this which is a CNC'd 4140 steel end cap with new
bearing.
With the aircraft on jacks or at least the tail tied down to remove all
weight off the nose gear, remove the bolt which connects the nose gear ram
to the over center linkage. Then push/pull STRAIGHT up/down and see if you
hear the noise or feel slop in the end cap. If you don't hear/feel the
movement the problem most likley is that your over center linkage is
improperly adjusted.
Hope this helps,
Always Yakin,
Doug
On Fri, Feb 6, 2009 at 6:38 PM, Bill VonDane <bill.mail@whiskeyvictor.com>wrote:
> Hey all... I was looking into a clunking noise I am hearing in the nose
> gear and found the upper mount of the nose gear actuator has some play in it
> where the bold goes through... I haven't taken it apart yet, but I was
> wondering if anyone had run into the before and what the fix might me...
>
> Thanks!
> -Bill
>
> *
>
> *
>
>
--
Always Yakin,
Doug Sapp
Phone 509-826-4610
Fax 509-826-3644
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|