Today's Message Index:
----------------------
1. 08:04 AM - Fuel Flow - Hoskins FT 101 Fuel Flow not working (rogrbal)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Fuel Flow - Hoskins FT 101 Fuel Flow not working |
Hoskins FT 101 Fuel Flow not working:
1. Lights stay on - all zeros
2. Unplugging connector in rear gets it working for a while, then it goes to #1
state again.
3. Resetting by doing #2 does not carry forward any fuel used between resets.
4. If reset it every time it goes to state #1, it will accumulate all the fuel
used while working. Only missing that used while in state #1.
Since it always shows some power applied, I do not think this is an intermittent
power problem.
Since it accumulates, I do not think this is a problem in the wire going to the
battery for residual power to retain accumulated fuel.
The transducer has three wires to it, maybe one of them is the problem.
Since doing #2 always fixes it, maybe the problem is in or near this plug?
Any ideas help??
Wiring diagram is available at
http://www.instrumenttech.com/productsupport.shtml
Look in the POH for the FT101A. It shows the plug pin diagram. Although I have
a 101 the only difference I can tell, is that the type reading - gallons, pounds,
etc. - is user resetable vice manufacturer set.
Thanks for your ideas. Need to fix it tomorrow - Sunday 7/19/09
Roger
--------
Thanks for the help.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=253619#253619
Attachments:
http://forums.matronics.com//files/ft101_fuelflow_poh_439.pdf
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|