Today's Message Index:
----------------------
1. 06:15 AM - Re: Engine won't air start (Mozam)
2. 02:28 PM - Parts needed (Kelley Monroe)
3. 07:21 PM - Re: Parts needed (Mike pankiewicz)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Engine won't air start |
I experienced the exact same symptoms several years ago.
I had taken my tach generator unit (a UMA tach generator) off the air start assembly
to repair it. When I removed it I failed to notice that a washer (spacer)
had fallen out that was under the tach generator screw on cap.
I reinstalled the tach generator without this washer and then had the same problem
you have. Air would get to the air start assembly, but not to the cylinders.
After a LONG period of head scratching, and after finding the washer on the hanger
floor, I finally solved the problem by replacing the washer.
Following this episode I experimented with different thickness spacers and found
what seemed to work best.
I hope your problem is as easy to fix. Best of luck,
Steve Dalton
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=276445#276445
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I have a CJ I need some parts for.
1.The radio receiver (WL5) tray that is attached to the receiver that
slides in on the right rear side panel.
2.The nose wheel retract cylinder boot.
3.The loop antenna plastic panel H2-0132-00.
4.Gaskets/seals for the center consumtion tank.
5.Oil cooler seals HB1-510-27x35x2.
6.Oil cooler drain gasket Q130101-3
I have checked with Doug on these parts and he is out of stock. If you
have any of these parts please contact me off list. Thanks Kelley
kelmonroe@comcast.net
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Parts needed |
I have some of the things what you.
WL5 Tray, I have a complete loop Antenna, not sure what you meen by "consum
tion tank"
PM me if you like.
Mike
--- On Sun, 12/6/09, Kelley Monroe <kelmonroe@comcast.net> wrote:
From: Kelley Monroe <kelmonroe@comcast.net>
Subject: Yak-List: Parts needed
I have a CJ I need some parts for.
1.The radio-receiver (WL5) tray-that is attached to the receiver that s
lides in on the right rear side panel.
2.The nose wheel retract cylinder boot.
3.The loop antenna plastic panel H2-0132-00.
4.Gaskets/seals for the center consumtion tank.
5.Oil cooler seals HB1-510-27x35x2.
6.Oil cooler drain gasket Q130101-3
I have checked with Doug on these parts and he is out of stock.- If you h
ave any of these parts please contact me off list.- Thanks Kelley- kelm
onroe@comcast.net
=0A=0A=0A
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|