Today's Message Index:
----------------------
1. 03:35 AM - Spinner Nut (Cpayne)
2. 12:54 PM - I'm Looking for an M14P (fighterguy)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Yes, agonizing at first to start the nut. Takes practice. I use a couple of wooden
paint sticks taped together for length, since you will need some offset anyway.
Then a bit of double sided tape on the end that will hold the nut in place
while you start by pulling the thin-guage safety wire. Once a turn is started
the long handled screwdriver can get a 1/2 turn on.
Then is time for the homemade aluminum wrench to get it snug. Do not tighten with
the steel wrench until all nuts are started and snug because the backplate
halves may need to be moved around slightly to line up.
Hence the easy chair and nearby refrigerator.
Craig Payne
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | I'm Looking for an M14P |
Hello All,
I am looking for a mid time M14P engine. Any and all who desire to sell an engine
please private message me here on this forum and I will get back to you.
I need an engine fairly soon!
Cheers.....
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=447565#447565
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|