Today's Message Index:
----------------------
1. 04:54 AM - Re: Air filter (A. Dennis Savarese)
2. 05:44 AM - Re: Air filter (greg.barnhard@gmail.com)
3. 09:04 AM - Re: Yak-List Digest: 4 Msgs - 04/02/17 (BKENNAMORE@aol.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Greg,Before I give you a 'yes' or 'no' answer, I'll try to help you underst
and where the filter is in the system so you can draw your own conclusion.
The original Russian air filter was below the pop off valve on the firewall
.=C2- Doug's filter essentially replaces the junk, Russian filter.=C2-
The line from the output of the filter goes to a firewall bulkhead fitting
and from there, directly back to the main air tank.=C2- There are no chec
k valve between the bottom of the 'Cross' on the firewall (below the pop of
f valve) back to the main air tank.=C2- Thus, when you open any fitting,
in the system between the bottom of the cross and the firewall, (this inclu
des opening Doug's SS filter), what do you think happens?=C2- Yep!=C2-
You're right!=C2- The main air tank will bleed off until depleted.
Hope this helps.Dennis
From: "greg.barnhard@gmail.com" <greg.barnhard@gmail.com>
To: yak-list@matronics.com
Sent: Monday, April 3, 2017 12:33 AM
Subject: Yak-List: Air filter
ail.com>
Dumb question for those of you with Doug Sapps SS air filter on a Yak 52: w
hen you change out the desiccant does all of the air from your air tank get
expelled when you disconnect the filter? Im trying to figure out if I'm ha
ving a senior moment or I screwed something up.
Thanks,
Greg
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=467977#467977
S -
WIKI -
-
=C2- =C2- =C2- =C2- =C2- -Matt Dralle, List Admin.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Dennis,
Makes perfect sense! Thank you!
Greg
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=467985#467985
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Yak-List Digest: 4 Msgs - 04/02/17 |
check main acc.shaft
In a message dated 4/3/2017 2:16:15 A.M. Central Daylight Time,
yak-list@matronics.com writes:
"woodja51" <mwuillemin@mac.com>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|