Today's Message Index:
----------------------
1. 09:24 AM - Re: brake metering valve (Gary Gabbard)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: brake metering valve |
Jon. It is an easy job. Just resealed mine. Just be careful when you take it
apart so you can put the parts back in the correct position internally. Rem
oving it from Acft , unscrew both air lines from valve remove two bolts and i
t comes right of airplane. Same to reinstall. I think Doug Sapp has the seal
kits. I also inSTALLED a new drain valve in the snot bottle in the belly th
at is associated with the brake system. Have fun. Gary. CJ N22YK. LAS
Sent from my iPad
> On May 9, 2017, at 11:20, Jon Boede <jonboede@hotmail.com> wrote:
>
> In the CJ:
>
>
> If I put the rudder pedals full left or full right and squeeze the brake h
andle I hear the brake system fill and then all the noises stop.
>
>
> If I put the rudder pedals to the middle position and squeeze, there's an o
n-going pneumatic noise that I'm not quite able to describe.
>
>
> Probably means my QS-2 brake metering valve is in need of TLC, yes? I see
that there's an overhaul kit for it... is that something that takes well to
an overhaul or best to just get a whole new valve?
>
>
> Jon
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|