---------------------------------------------------------- Yak-List Digest Archive --- Total Messages Posted Thu 07/05/18: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:22 PM - CJ Prop Blade Angle Procedure (PS) 2. 10:46 PM - Re: CJ Prop Blade Angle Procedure (Walter Lannon) ________________________________ Message 1 _____________________________________ Time: 06:22:10 PM PST US Subject: Yak-List: CJ Prop Blade Angle Procedure From: "PS" I have been fighting setting blade angles for my Housai powered CJ since last Friday. I do not understand where to measure the angle. I tried 1000mm from the prop oil supply tube and I tried 8 from the blade tip. What is correct? I am curious if the governor is set incorrectly. Phil -------- Phil Read this topic online here: http://forums.matronics.com/viewtopic.php?p=481431#481431 ________________________________ Message 2 _____________________________________ Time: 10:46:56 PM PST US From: "Walter Lannon" Subject: Re: Yak-List: CJ Prop Blade Angle Procedure Hi Phil; 1000 mm from the C/L is correct but if you just want to check that the blades are correctly set check the scribe mark and the scale at the blade grip. The scribe mark should be at the center mark. If they both look the same and you have no issues with vibration, etc. sit down and have a beer or two. If you suspect a governor issue run through the governor setting procedure in the manual and make sure there are no loose control system bolts or clamps etc. allowing the cable housing to move. Cheers; Walt -----Original Message----- From: PS Sent: Thursday, July 05, 2018 6:21 PM Subject: Yak-List: CJ Prop Blade Angle Procedure I have been fighting setting blade angles for my Housai powered CJ since last Friday. I do not understand where to measure the angle. I tried 1000mm from the prop oil supply tube and I tried 8 from the blade tip. What is correct? I am curious if the governor is set incorrectly. Phil -------- Phil Read this topic online here: http://forums.matronics.com/viewtopic.php?p=481431#481431 --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message yak-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Yak-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/yak-list Browse Digests http://www.matronics.com/digest/yak-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.