---------------------------------------------------------- Yak-List Digest Archive --- Total Messages Posted Fri 09/07/18: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:13 AM - Re: V530 prop blades settings (\) ________________________________ Message 1 _____________________________________ Time: 05:13:45 AM PST US From: "\"" Subject: Re: Yak-List: V530 prop blades settings Walt, Much thanks. Those numbers sound very familiar and have jogged this aged m emory. You're correct about no published settings for the CJ-6 as the M-14 P. I believe the first M-14 powered CJ-6 was done here in the states by Bu d Harrell. I'll use these numbers, they make sense. Cheery O ;-) Jim "Pappy" Goolsby -----Original Message----- From: Walter Lannon Sent: Fri, Sep 7, 2018 12:53 am Subject: Re: Yak-List: V530 prop blades settings Pappy; I don=99t believe there are any published blade angle settings for th e V530/M14P on the CJ 6. The only angle specs. I have seen are included in an addendum to the M14P M aintenance manual. These are =9Cpresumably=9D for the Yak 52 a nd/or the YaK 55. I have used them for the CJ6 installation and seem to work fine. Angles are always set at low pitch and checked for conformity at high pitch .. Low Pitch -- 14 deg. 30 min. +/_ 10 min. Max. between blades 10 min. (p ersonally I do not allow more than 5 min. here). High pitch -- 34 deg. 20 min. +/_ 20 min. The Polish manual you have is for the 260 HP AI14R installation on the Wilg a using a 10=9D larger dia. prop at a Max. of 2350 RPM Cheers; Walt From: " Sent: Thursday, September 06, 2018 8:43 AM Subject: Yak-List: V530 prop blades settings While disassembling my B530TA prop on my CJ-6 for a good cleaning, inspect ion, and replacing oil and grease seals, I neglected to measure the blade angles. Can anyone of you experts out there tell me the blade angle and if that an gle is the low pitch or high pitch angle. I have an overhaul manual for the prop, but its written for the Velga airc raft and I know the angles in this manual are wrong for the CJ. I do know that the angle is set at the ONE meter point from the center of the prop shaft. I need to know the angle and if at the low pitch or high pitch stops. I did this several years ago and simply didn't write down the correct numb ers in that manual. Thanks in advance. Jim "Pappy" Goolsby I Virus-free. www.avast.com ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message yak-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Yak-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/yak-list Browse Digests http://www.matronics.com/digest/yak-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.