Today's Message Index:
----------------------
1. 07:17 AM - Cylinder Head Temperature Gages (Clouddog)
2. 01:26 PM - Need gear actuator seal. (motoadve)
3. 08:53 PM - Re: Need gear actuator seal. (Walter Lannon)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Cylinder Head Temperature Gages |
I have a stock Housai with one cylinder head temp probe on the #4 cylinder reading
in the front cockpit and one on the #1 cylinder reading in the rear cockpit.
Nether sparkplug has the crush washer installed. The rear gage has always
read 20 degrees cooler which is normal but both were rock solid. I have cleaned
the rings that go under the spark plug and made sure the wiring forward of firewall
looked normal. These should be two independent readings going to two
different gages or so I think. During flight, both gage readings are low and varying
constantly on both gages. When i shut down, both gages read steady and
normal. What would cause both gages to act stupid and then settle down after
aircraft is shut down?
I would think they are grounding out on the frame due to vibration during the time
the engine is running but BOTH!! There has got to be a common connection
I would think causing both gages to behave similar.
Greg "Clouddog " Wrobel
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=496909#496909
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Need gear actuator seal. |
Need the seal for the landing gear actuator, Doug Sapp does not have them in stock
at the moment.Anyone has a spare that can sell it to me?
--------
www.Backcountry182.com
Cessna 182 P
CJ -6
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=496915#496915
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Need gear actuator seal. |
Possibly may have one but which actuator?
Suggest you send Parts Cat. page with item identified.
Walt
wlannon@shaw.ca
-----Original Message-----
From: motoadve
Sent: Thursday, June 18, 2020 1:23 PM
Subject: Yak-List: Need gear actuator seal.
Need the seal for the landing gear actuator, Doug Sapp does not have them in
stock at the moment.Anyone has a spare that can sell it to me?
--------
www.Backcountry182.com
Cessna 182 P
CJ -6
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=496915#496915
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|