----------------------------------------------------------
                           Yak-List Digest Archive
                                      ---
                     Total Messages Posted Sat 12/26/20: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 05:24 PM - Re: strange A/H nuts & generator brushes?  (AlaskaChang801)
     2. 07:52 PM - Re: Re: strange A/H nuts & generator brushes?  (Justin Drafts)
 
 
 
________________________________  Message 1  _____________________________________


Time: 05:24:45 PM PST US
Subject: Yak-List: Re: strange A/H nuts & generator brushes?
From: "AlaskaChang801" <themilnes95@gmail.com>


I just replaced my back AI and mine had 4mm nut and washer combo from the previous
owner as the plate wasn't the stock one. Anyway, I understand the desire to
keep the look stock etc, but if you can't get these from Doug Sapp, then you
might have to buy alternative ones from MacMaster-Carr. They have M4 cap nuts,
but not sure of the depth of thread so you may have to add a couple flat washers
to take up the thickness if they bottom out in the cap. Or just buy 4mm Nylok
nuts and go that way.


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=499821#499821


________________________________  Message 2  _____________________________________


Time: 07:52:26 PM PST US
From: Justin Drafts <draftsjust417@gmail.com>
Subject: Re: Yak-List: Re: strange A/H nuts & generator brushes?

Ya... that's a good plan-B.
Great to not be in a rush or AOG...

Thanks!
Justin

On Sun, Dec 27, 2020 at 5:59 AM AlaskaChang801 <themilnes95@gmail.com>
wrote:

>
> I just replaced my back AI and mine had 4mm nut and washer combo from the
> previous owner as the plate wasn't the stock one. Anyway, I understand the
> desire to keep the look stock etc, but if you can't get these from Doug
> Sapp, then you might have to buy alternative ones from MacMaster-Carr. They
> have M4 cap nuts, but not sure of the depth of thread so you may have to
> add a couple flat washers to take up the thickness if they bottom out in
> the cap. Or just buy 4mm Nylok nuts and go that way.
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=499821#499821
>
>

 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               yak-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/Yak-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/yak-list
Browse Digests                   http://www.matronics.com/digest/yak-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.