Today's Message Index:
----------------------
1. 03:05 PM - Re: Yak canopy Ball replacement (AlaskaChang801)
2. 08:39 PM - JTY-1 solid state voltage regulator (Jon Boede)
3. 10:23 PM - Nanchang Parts Manuals (glipaz)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Yak canopy Ball replacement |
Not a Yak replacement I know!!, BUT I just redid both mine on the CJ. I had the
canopies apart for replacement so it was worth while doing while it was all in
pieces. Can't say it would be impossible to do without taking the canopy apart
but it will be harder.
I replaced the wire with 3/16" wire cable from the local hardware store. I then
crimped new ends on and trimmed them. While I had the latch apart I readjusted
the tension and the overhead ball pull now lifts the latch pin nicely. I'll
see if I have some pictures on my phone I can let you see the end result.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=501121#501121
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | JTY-1 solid state voltage regulator |
Anybody have any information on the JTY-1 solid state voltage regulator for
the stock generator?
I have one and I'm converting to a B&C alternator.
Looks like the way the JYT-1 is set up its pretty much just a matter of con
necting the canon plug wires to the right pins on the B&C LS-1A regulator.
But any information would be helpful. Doug sells the JTY-1 with a "convers
ion kit" -- anybody ever done that?
Thought I'd check here before bugging Doug too much.
Thanks,
Jon
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Nanchang Parts Manuals |
Already posted on FB:
Looking for a set of Nanchang Parts manuals with English translations. But, there
are two versions of these, one set with the English below the Chinese and
one set with the English beside the Chinese. Looking for PDFs of the latter as
they have significantly fewer pages to print into a hard copy.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=501128#501128
Attachments:
http://forums.matronics.com//files/img_8811_162.jpg
http://forums.matronics.com//files/img_8810_150.jpg
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|