Today's Message Index:
----------------------
1. 06:37 AM - Front air gauge for a CJ6 (Dave Jester)
2. 08:15 AM - Mixture cable CJ6 (jlpartington@reagan.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Front air gauge for a CJ6 |
Morning all, looking for a front cockpit air gauge for a CJ6. Asking for a friend.
I drive a Yak.
Sent from my iPhone
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Mixture cable CJ6 |
=0AI am finally finishing up the install on Doug Sapp's project motor I pic
ked up as he closed down business.=0A =0AI have been learning and relearnin
g a lot and the end is insight.=0A =0AI have seen this issue before but it
has been so long (over 30 years) so I need some reminding.=0A =0AThe mixtur
e cable is binding after about an inch of movement toward lean. The cable
is retracting as seen from the engine. I see no huge/sharp bends in the tu
be, no worse than many that are working.=0A =0AI am thinking it must be whe
re the solid end meets the cable in side and a minor kink is restricting mo
vement. How long are the solid rod ends? Perhaps that will help me locate
the issue.=0A =0AOr I am all wet! Any ideas, or helpful hints? I am sure
that I am not the first.=0A =0AJim (Pooh) Partington=0A =0A817.917.6806
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|