Today's Message Index:
----------------------
1. 12:34 PM - power supplies for pre charging strobes (Joemotis@aol.com)
2. 12:46 PM - King KR 87 ADF / KI 227 Indicator & KA 44 antenna (Ray Montagne)
3. 07:31 PM - 601 Rear Fuselage Alignment (David Tellet)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | power supplies for pre charging strobes |
--> Zenith-List message posted by: Joemotis@aol.com
I posted a couple of weeks ago about using a dpdt switch and a 3 volt power
supply to pre charge the strobe power supplies and came up with these. A bit
pricey but certainly up to the task.
http://www.mouser.com/catalog/618/1154.pdf
Joe Motis
601 XL
Waiting for wing skins (again!)
Do not archive
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | King KR 87 ADF / KI 227 Indicator & KA 44 antenna |
--> Zenith-List message posted by: Ray Montagne <ac6qj@earthlink.net>
Hello list,
I=B9m looking for wiring information for a King KR-87 ADF / KA 44 antenna. If
you can offer any information on the pin assignments for signal names
between the KR-87 ADF receiver and KA 44 antenna, power connections to the
KR-87, audio connections from the KR-87 and connections between the KR 87
ADF receiver and KI 227 indicator then please reply off list.
DO NOT ARCHIVE
Best Regards, Ray Montagne
Cupertino, CA
Zenith Aircraft Zodiac CH-601-XL
Build Status: Rudder completed
Elevator Completed
Stabilizer Completed
Flaps Completed
Ailerons Completed
Right Wing Completed
Right Wing Tip Completed
Left Wing Completed
Right Wing Tip Completed
Fuselage Under Construction
NOTE: Heavy SPAM filters in place. Replies that do not include
the word 'Zenith' or 'Zodiac' will be rejected and will not
be viewable by me.
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | 601 Rear Fuselage Alignment |
--> Zenith-List message posted by: David Tellet <telletdl99@mac.com>
List -
Any tips on aligning the rear fuselage? I know I don't want any
twist in the fuse, as it says in the instructions, but I'm not sure the
best way to measure this or to fix it. I first made the top longerons
level with the bottom and the worktable, but then the sides were at
slightly different angles to the worktable. When I fix the sides, then
the level is off.
Any ideas would be appreciated. Thanks.
David Tellet, 601HD, ~50% done
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|