Today's Message Index:
----------------------
1. 07:49 AM - Re: centre wing, HD(S) question (LarryMcFarland)
2. 04:43 PM - Re: centre wing, HD(S) question (Carlos Sa)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: centre wing, HD(S) question |
Yes Carlos,
I had to bump the plate into a nearly imperceptible curve to get a fit.
Larry McFarland 601HDS at www.macsmachine.com
Carlos Sa wrote:
> Hello, all
>
> Did anybody bother to bend plate 6V11-4 to fit the curvature of the wing?
> I see small gaps at the front and rear, something around 1.0 mm ...
> see attached file...
>
>
> Carlos
> CH601-HD, plans
>
> ------------------------------------------------------------------------
>
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: centre wing, HD(S) question |
Done - harder to describe than to do... :-)
Thanks all for the replies
Carlos
do not archive
2009/8/11 LarryMcFarland <larry@macsmachine.com>
>
> Yes Carlos,
> I had to bump the plate into a nearly imperceptible curve to get a fit.
>
> Larry McFarland 601HDS at www.macsmachine.com
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|