---------------------------------------------------------- Zenith-List Digest Archive --- Total Messages Posted Fri 08/28/09: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 01:46 AM - Re: Choke cable and Rotax 912 (Martin Pohl) 2. 07:29 AM - Re: Choke cable and Rotax 912 (John Goodings) 3. 11:39 PM - 601XL Cowling (Peter W Johnson) ________________________________ Message 1 _____________________________________ Time: 01:46:43 AM PST US Subject: Zenith-List: Re: Choke cable and Rotax 912 From: "Martin Pohl" George and Leo Thank you for your input. I will keep the system as is and just lubricate it a little bit with graphite. Cheers Martin -------- Martin Pohl Zodiac XL QBK 8645 Jona, Switzerland http://www.pohltec.ch/ZodiacXL/Main.html Read this topic online here: http://forums.matronics.com/viewtopic.php?p=260160#260160 ________________________________ Message 2 _____________________________________ Time: 07:29:06 AM PST US From: John Goodings Subject: Zenith-List: Re: Choke cable and Rotax 912 Six years ago when I was installing our Rotax 912S I was warned by an experienced builder that the choke cable is notoriously hard to pull. True! I was also told not to worry about it - it will work fine. Also true! A couple of times a year, we shoot Rust Check (it is a very thin oil in a spray can, sold at Canadian Tire in Canada, but there will be counterparts everywhere) into each end of the cable sheath. It seems to suck its way in along the cable by capillary action. The only problem we once had was that the choke did not fully release when we pushed it in. Another application of Rust Check took care of the problem. John Goodings, C-FGPJ, CH601HD with R912S, Carp/Ottawa/Toronto. ________________________________ Message 3 _____________________________________ Time: 11:39:11 PM PST US From: "Peter W Johnson" Subject: Zenith-List: 601XL Cowling Hi Guys, I received my camlocs for the cowling from ASSC the other day. Attached is a photo. The photo shows:- 40S5-3S SS CAMLOC STUD 4002-NS CAMLOC GROMMET 214-16ND CAMLOC 4002 Receptacle How do I get the stud into the grommet. Do I have to remove the pin? If so, how? Cheers Peter Wonthaggi Australia http://zodiac.cpc-world.com ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message zenith-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/zenith-list Browse Digests http://www.matronics.com/digest/zenith-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.