Today's Message Index:
----------------------
1. 04:46 AM - Re: Re: Push/Pull tubes (New Design) (Peter Chapman)
2. 05:37 AM - Re: Push/Pull tubes (New Design) (n1269k)
3. 09:12 AM - Re: Re: Push/Pull tubes (New Design) (Afterfxllc@aol.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Push/Pull tubes (New Design) |
At 01:08 05-12-09, you wrote:
>
>Are you sure about the range of motion and angle of motion being the
>same as the original design?
>
Given that the bellcrank is held on with an big C-clamp and there's
some sort of socket wrench lying about in the photo, he may not quite
be finished yet and is giving us a sneak peak at his new setup. :-)
Peter Chapman
Toronto, ON
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Push/Pull tubes (New Design) |
Jeff
RV-9 bell cranks?
Terry
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=276289#276289
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Push/Pull tubes (New Design) |
Yes sir they also are used on the RV-8 I believe.
The range of movement is the same as our bell crank but theirs is 4130
moly. The difference between the total length of the push pull tubes is 500 mm
(ours longer).
I think it will be more cost effective to go with 11/8 .049 wall tubes just
because ACS doesn't carry .035. The same bell crank can be used as a
direct replacement for the Zenith bell crank also and the advantage to that is
it can be bolted in place with the Van's moly brackets.
Jeff
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|