---------------------------------------------------------- Zenith-List Digest Archive --- Total Messages Posted Tue 04/13/10: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 08:21 AM - Re: 601 Upgrade Question (Scotsman) 2. 08:22 AM - Re: 601 Upgrade Question (Scotsman) 3. 01:37 PM - 601XL main spar question (Sabrina) ________________________________ Message 1 _____________________________________ Time: 08:21:26 AM PST US Subject: Zenith-List: Re: 601 Upgrade Question From: "Scotsman" Excuse the potential stupidity but I thought that the purpose of putting a hole between the existing holes was to ensure that you don't use the original holes (leaving them hidden on the underside). Therefore you would have a pitch 40 on the new holes not a pitch 20 with elongation (and therefore potential cracking) on the original holes. Does this make sense or did I not read the plans properly? -------- Cell +27 83 675 0815 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=294077#294077 ________________________________ Message 2 _____________________________________ Time: 08:22:30 AM PST US Subject: Zenith-List: Re: 601 Upgrade Question From: "Scotsman" I also thought that the use of solid rivets would negate the need for pitch 20 due to their comparatively higher shear strength? -------- Cell +27 83 675 0815 Read this topic online here: http://forums.matronics.com/viewtopic.php?p=294078#294078 ________________________________ Message 3 _____________________________________ Time: 01:37:06 PM PST US Subject: Zenith-List: 601XL main spar question From: "Sabrina" Hey guys I am about to open up my wings between nose rib 5 and nose rib 6 to install mounts for my external main spar struts. As I remember, the solid rivets are pitched 40mm on center. Could someone tell me the actual distance between the driven rivets on the forward side of their main spar? (i.e. the space available on the front spar doublers between rivets) (As I recall, -5s are used that far outboard, so there is more space than further inboard where -6 rivets were used) Thank you so much! Sabrina Read this topic online here: http://forums.matronics.com/viewtopic.php?p=294103#294103 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message zenith-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/zenith-list Browse Digests http://www.matronics.com/digest/zenith-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.