Today's Message Index:
----------------------
1. 01:16 PM - tie-down bolt (Carlos Sa)
2. 07:22 PM - Re: tie-down bolt (Ron Lendon)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Hello, listers
What have you used as a tie-down bolt?
The only one I found at AS&S seems too large:
http://www.aircraftspruce.com/catalog/pspages/tieDowneye.php
(The only specification I see in the plans is 5/16" tie down ring...)
Thanks for your input
Carlos
CH601-HD, plans
working on rear fuselage and thinking of were to store parts... guest room
taken (centre wing), office taken (myself, desk, rolls of alum, rudder),
storage room taken (landing gear and miscelaneous parts, old fridge, etc.),
garage taken (2 wing panels, 2 fuel tanks, stabilizer, elevator, bending
brake - and, of all things, a car!)
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: tie-down bolt |
I looked around the local hardware stores and found nothing heavy duty enough,
so I called Zenith and they shipped one out. $4.80 plus s&h.
--------
Ron Lendon, Detroit, MI
WW Corvair with Roy's Garage 5th bearing
Zodiac XL, ScrapBuilder ;-)
http://www.mykitlog.com/rlendon
Corvair Engine Prints:
http://www.zenith.aero/profile/RonLendon
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=311622#311622
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|