----------------------------------------------------------
                           Zenith-List Digest Archive
                                      ---
                     Total Messages Posted Wed 09/08/10: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 09:18 PM - AN 115 Cable Shackle  (MHerder)
     2. 09:53 PM - Re: AN 115 Cable Shackle  (Rick Lindstrom)
 
 
 
________________________________  Message 1  _____________________________________


Time: 09:18:19 PM PST US
Subject: Zenith-List: AN 115 Cable Shackle
From: "MHerder" <michaelherder@beckgroup.com>


WHen using an an 115 cable shackle, and torquing to the specified value for an
AN 3, it is clamping to my aileron bellcrank and causing a bit of binding.  Is
it ok not to torque to full value if using a castellated nut? Should a bushing
be used?

--------
One Rivet at a Time!


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=311898#311898


________________________________  Message 2  _____________________________________


Time: 09:53:30 PM PST US
From: Rick Lindstrom <tigerrick@mindspring.com>
Subject: Re: Zenith-List: AN 115 Cable Shackle


Hi, Mike!

I don't think that standard torque values apply when using bolts as pivots, so
I'd torque it down until you achieve the desired clearance, and then use a castellated
nut cotter pinned in place through the hole in the bolt. (You DO have
a hole in the bolt, right?)

A bushing? Only if more than normal wear is anticipated.

Just my opinion(s).

Rick 

ZenVair N42KP


-----Original Message-----
>From: MHerder <michaelherder@beckgroup.com>
>Sent: Sep 8, 2010 9:14 PM
>To: zenith-list@matronics.com
>Subject: Zenith-List: AN 115 Cable Shackle
>
>
>WHen using an an 115 cable shackle, and torquing to the specified value for an
AN 3, it is clamping to my aileron bellcrank and causing a bit of binding.  Is
it ok not to torque to full value if using a castellated nut? Should a bushing
be used?
>
>--------
>One Rivet at a Time!
>
>
>Read this topic online here:
>
>http://forums.matronics.com/viewtopic.php?p=311898#311898
>
>


 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               zenith-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/Zenith-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/zenith-list
Browse Digests                   http://www.matronics.com/digest/zenith-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.