Today's Message Index:
----------------------
1. 03:46 PM - Re: canopy side frame 601xl (Bryan Martin)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: canopy side frame 601xl |
On mine, I put the front edge under the front flashing. I used 3M molding tape
between the upper edge of the front flashing and the plexiglas. I put the rubber
trim strip over the rear end of 3C3-3 and used 3M weatherstrip adhesive under
the flashing in that area and to attach the rubber trim to the canopy. This
has worked very well for me.
3M molding tape is a gray foam double sided tape designed to attach vinyl moldings
on the sides of cars.
3M weatherstrip adhesive is a rubbery contact adhesive. You put it on both surfaces
and let it dry to a tacky state and then press the two pieces together.
On Dec 14, 2010, at 3:57 PM, Joe wrote:
> help how to fasten side flashing 6c3-3 at ea end heard mintion of
> glue at some point if so what type.
>
> thanks
> Joe Ham
>
>
--
Bryan Martin
N61BM, CH 601 XL,
RAM Subaru, Stratus re-drive.
do not archive.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|