Today's Message Index:
----------------------
1. 11:16 AM - Re: Drilling Front Axle (Steve Freeman)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Drilling Front Axle |
Thanks to all for your suggestions and special props to Don H. for helping.
We used a drill guide and your suggestions and got the axle drilled
perfectly on the first try.
Thank you,
Steve Freeman
From: owner-zenith-list-server@matronics.com
[mailto:owner-zenith-list-server@matronics.com] On Behalf Of Steve Freeman
Sent: Monday, June 06, 2011 10:53 AM
Subject: Zenith-List: Drilling Front Axle
Hi Guys,
Does anyone have a suggestion (or tool recommendation) for drilling the
front axle to receive cotter pins on both sides? Is this drilled inside the
turrets of the castle nuts when snugged up against fork? I have never been
terribly successful at drilling in to "round" surfaces and this one is so
think I will admit I am apprehensive to try.
Any thoughts or suggestions would be appreciated.
Thank you,
Steve Freeman
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|