Today's Message Index:
----------------------
1. 08:31 AM - Re: Battery location (Joe)
2. 09:18 AM - Re: Battery location (mtherr@yahoo.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Battery location |
i,m using a power sonic battery # ps 12350
have an access just below and a little foward of the elavator
grounded to door frame ran the wire through a plastic tube mtd
under neath 6b164 battery wt 25 lb,s
----- Original Message -----
From: joe ham
To: zenith-list@matronics.com
Sent: Tuesday, April 24, 2012 12:04 PM
Subject: RE: Zenith-List: Battery location
Hi Joe,
If I am not mistaken this puts your battery 4" in front of the Front
HT Frame. I have never seen a battery this far back. Did you also
install an access door so you can get to the batter for service? Can
you describe how you get your cables to the front and where are you
grounding the negative terminal?
Also - what kind of battery do you have and how much does it weigh?
Thanks for responding,
Steve
From: owner-zenith-list-server@matronics.com
[mailto:owner-zenith-list-server@matronics.com] On Behalf Of Joe
Sent: Tuesday, April 24, 2012 8:20 AM
To: zenith-list@matronics.com
Subject: Re: Zenith-List: Battery location
steve i have the same engine in 601xlb my battery is 4" from 6b1-1
i can move
up to 6to8" foward i have not flown yet wt & balance checed good.
have air worthenes cert.working on byanual.
----- Original Message -----
From: joe ham
To: zenith-list@matronics.com
Sent: Monday, April 23, 2012 2:58 PM
Subject: Zenith-List: Battery location
Hi List -
Anyone out there who might be building a 601XL or 650 using a
Lycoming 0235 engine.Where are you putting your battery and what kind
are you using? I know this engine is heavier than a lot of other
solutions so I am concerned about the forward C/G and have no idea how
to figure that BEFORE the airplane is complete.
Any help or advice is certainly appreciated.
Thanks,
Steve Freeman
href="http://www.matronics.com/Navigator?Zenith-List">http://www.matron
href="http://forums.matronics.com">http://forums.matronics.comhref="h
ttp://www.matronics.com/contribution">http://www.matronics.com/c
http://www.matronics.com/Navigator?Zenith-Listhttp://forums.matronics.com
http://www.matronics.com/contribution
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Battery location |
What wiring gauge do you use? 2awg? 4awg?
work
-----Original Message-----
From: "Joe" <Joe@hambrothers.com>
Sender: owner-zenith-list-server@matronics.com
Subject: Re: Zenith-List: Battery location
This is a multi-part message in MIME format.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|