Today's Message Index:
----------------------
1. 05:00 PM - CH601-HD(S) fuselage assembly (Carlos Sa)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | CH601-HD(S) fuselage assembly |
Hello, folks
My aluminum stack is finally starting to resemble an aircraft (if you have
a lot of imagination, that is):
http://www.zenith.aero/photo/img-6058
When I put the front side skins in place (just to have an idea of what it
would look like), I noticed the interference between the side skins, heel
support and floor (the rolled end of the floor).
The attached pics show the offending area.
The instructions simply say "trim as required" (or something like that).
To me, it seems I'll have to remove a semi-circle one or two inches in
diameter - as I haven't seen any comments about this, I am a little
concerned.
I also have looked at a few of the CH601 sites still on-line, but I did not
find any picture or comment that would clarify this.
Thanks in advance for your comments / suggestions
Carlos
CH601-HD, plans
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|