Today's Message Index:
----------------------
1. 05:23 AM - Re: Recently completed Fuel Gauge Question (steveadams)
2. 06:53 AM - Re: EA-81 - Going Going Gone... (Gig Giacona)
3. 12:32 PM - Re: Re: LSA OR EXPERIMENTAL (Jim Belcher)
4. 12:45 PM - Re: Re: EA-81 - Going Going Gone... (Craig Payne)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Recently completed Fuel Gauge Question |
Even if you plan long legs, an accurate measure of the upper half of the tanks
is relatively unimportant. Accurate readings from 10 gal in each tank on down
gives you plenty of time to compare your actual fuel burn to what was planned,
and modify your plan as required. That's assuming you're not doing 5 hour legs
over open water or other places with no options for landing other than your
departure and destination airport.
Steve
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 4745#204745
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: EA-81 - Going Going Gone... |
Craig, are you "pavel569"?
craig(at)craigandjean.com wrote:
>
> > That no shipping is gonna cost you a several thousand dollars.
> >
> >
>
> Depends on where you live :-)
>
> 1 hour 36 minutes left, $2250. Tick, tick, tick, ...
>
> Craig, Utah
>
> Do not archive
--------
W.R. "Gig" Giacona
601XL Under Construction
See my progress at www.peoamerica.net/N601WR
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 4765#204765
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: LSA OR EXPERIMENTAL |
On Tuesday 16 September 2008 09:25, Jay Maynard wrote:
>
> On Tue, Sep 16, 2008 at 07:02:06AM -0700, Dirk Zahtilla wrote:
> > I'm not an expert but I believe you can register as ELSA since the 601XL
> > is being built as a SLSA by the factory.
>
> No. An ELSA must be built from a kit *by the same manufacturer* as the
> SLSA. AMD is the SLSA manufacturer; Zenith Aircraft Company is the kit
> supplier. AMD would have to sell the kits in order for them to be eligible
> for E-LSA.
As more and more of the participants on this forum provide information, what I
suspect (but don't know) is that the players have created two companies for
liability purposes. If AMD is legally disconnected from the kits, then they
probably cannot be sued if someone builds a kit and does considerable damage
to themselves or someone else with it. But an attorney would need to give the
final word on that conjecture.
Up to this point, I had believed (incorrectly) that AMD and Zenith were the
same company. That evidently is not the case.
--
=============================================
Those who can, do. Those who can't, sue.
================================================
Jim B. Belcher
BS, MS Physics, math, Computer Science
A&P/IA
Instrument Rated Pilot
General Radio Telephone Certificate
================================================
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: EA-81 - Going Going Gone... |
No, I actually didn't bid (although I considered it). But Pavel is active on
the list (or has been). Look like he lives in SoCal.
As expected the bidding picked up at the end and the engine went for $4383 -
a good deal if it works out.
-- Craig
-----Original Message-----
From: owner-zenith601-list-server@matronics.com
[mailto:owner-zenith601-list-server@matronics.com] On Behalf Of Gig Giacona
Sent: Wednesday, September 17, 2008 7:53 AM
Subject: Zenith601-List: Re: EA-81 - Going Going Gone...
Craig, are you "pavel569"?
craig(at)craigandjean.com wrote:
>
> > That no shipping is gonna cost you a several thousand dollars.
> >
> >
>
> Depends on where you live :-)
>
> 1 hour 36 minutes left, $2250. Tick, tick, tick, ...
>
> Craig, Utah
>
> Do not archive
--------
W.R. "Gig" Giacona
601XL Under Construction
See my progress at www.peoamerica.net/N601WR
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 4765#204765
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|