Today's Message Index:
----------------------
1. 04:18 AM - Axle drill Guide to suit GAC 5018 (aussiech650)
2. 08:49 AM - Re: Re: Firewall Forward Kit from Jab USA/Camloc Fasteners (a.f.rupp@att.net)
3. 05:56 PM - Re: Axle drill Guide to suit GAC 5018 (Ron Lendon)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Axle drill Guide to suit GAC 5018 |
I am trying to buy a couple of axle drilling guides to suit the GAC 5018 axle but
I am unable to contact kobush welding and machining via the email.
They ask you to contact them before ordering if you are outside the states.
I am in Australia. Can anyone help me with this, is there another supplier.
Greg Cox
Sydney, Australia
greg@gas-n-go.com.au
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=267325#267325
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Firewall Forward Kit from Jab USA/Camloc Fasteners |
Mike,
A rub strip on the cowling can snug up those fasteners also.
Al Rupp
601XL 765AR
Lake Placid, NY
-------------- Original message from "AZFlyer" <millrML@aol.com>: --------------
>
> Many thanks to all that responded so quickly to my camloc question.
>
> Now back to building.
>
> Thanks again,
> Mike
>
> --------
> Mike Miller @ millrml@aol.com
> 601 XL, 3300, Dynon
>
> Remember, "the second mouse gets the cheese"!
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=267233#267233
>
>
>
>
>
>
>
>
>
>
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Axle drill Guide to suit GAC 5018 |
Just take this to a machine shop and have them make it up from 3/4" to 1" thick
steel. It shouldn't cost to much.
Made one up myself right from this picture. I omitted the 1.25" center hole, made
it 3/8", and it worked out just fine.
--------
Ron Lendon, Clinton Township, MI
WW Corvair with Roy's Garage 5th bearing
Zodiac XL, ScrapBuilder ;-)
http://www.mykitlog.com/rlendon
Corvair Engine Prints:
http://home.comcast.net/~rlendon/site/
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=267411#267411
Attachments:
http://forums.matronics.com//files/grovegeardrillguide_127.jpg
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|