Today's Message Index:
----------------------
1. 11:13 AM - Chat (George Race)
2. 09:34 PM - Brake caliper location (chuck960)
3. 09:49 PM - Re: Brake caliper location (Paul Mulwitz)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Live Chat Room every Monday evening around 8:00 EDT
www.mykitairplane.com <blocked::http://www.mykitairplane.com/>
Click on the Chat Room link at the top of the page.
George
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Brake caliper location |
Looking at some photos it seems that the best location for the brakes are the trailing
edge of the gear. This makes the most sense to me. The Grove instructions
show them in front and angled down.
Can anyone clarify this? Does the angle make any difference?
Chuck
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=283456#283456
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Brake caliper location |
Hi Chuck,
I don't think it makes a lot of difference, but I mounted my brake calipers
on the front of the wheel. I chose this position because I was a little bit
concerned about all the junk kicked up by the wheel damaging the caliper. I
think it is less likely to hit the caliper when the caliper is in front.
Paul
XL awaiting upgrade kit
-----Original Message-----
From: owner-zenith601-list-server@matronics.com
[mailto:owner-zenith601-list-server@matronics.com] On Behalf Of chuck960
Sent: Monday, January 25, 2010 9:34 PM
Subject: Zenith601-List: Brake caliper location
Looking at some photos it seems that the best location for the brakes are
the trailing edge of the gear. This makes the most sense to me. The Grove
instructions show them in front and angled down.
Can anyone clarify this? Does the angle make any difference?
Chuck
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|