Today's Message Index:
----------------------
1. 05:14 AM - Re: panel trim (jaybannist@cs.com)
2. 05:45 AM - Wire stop (Bob Gibfried)
3. 01:06 PM - Paint Weight (Tim Juhl)
4. 02:23 PM - Re: Paint Weight (Paul Mulwitz)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Chuck,
In my case, it came from Zenith. I think it was introduced with the 750.
Jay
I've viewed photos of XL's with this nice looking trim around the instrume
nt
panel. Can anyone tell me where this comes from?
Chuck,
CH650
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=302155#302155
========================
===========
========================
===========
========================
===========
========================
===========
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Has anyone come up with a good way to fasten the wire control to the fuel
shut off valve? I've tried the whole through a bolt with nuts on both sides
and the threaded tube with the hole and bolt but both methods slip in time.
Got to be a better way.
Bob, Wichita
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Has anyone ever weighed an aileron before and after painting? I wonder how much
of a weight increase is seen with a typical paint job.
Obviously I'm thinking of issues that might occur with the aileron balance.
Tim
--------
______________
CFII
Champ L16A flying
Zodiac XL - Jabiru 3300A
Tearing wings apart for modification
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=302263#302263
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Hi Tim,
Just a guess . . . I would think a proper (i.e. thin) paint job would weigh
considerably less than one of those steel weights. It would take perhaps
one or two ounces of thinned paint per coat and maybe4 or 5 coats. Of
course, most of the weight of the liquid paint would be thinner.
Paul
XL - doing upgrade - fighting main spar rivet removal.
-----Original Message-----
From: owner-zenith601-list-server@matronics.com
[mailto:owner-zenith601-list-server@matronics.com] On Behalf Of Tim Juhl
Sent: Wednesday, June 23, 2010 1:07 PM
Subject: Zenith601-List: Paint Weight
Has anyone ever weighed an aileron before and after painting? I wonder how
much of a weight increase is seen with a typical paint job.
Obviously I'm thinking of issues that might occur with the aileron balance.
Tim
--------
______________
CFII
Champ L16A flying
Zodiac XL - Jabiru 3300A
Tearing wings apart for modification
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=302263#302263
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|