Zenith601-List Digest Archive

Sun 05/29/11


Total Messages Posted: 4



Today's Message Index:
----------------------
 
     1. 06:18 AM - Re: brake lines with dual sticks (James E. Schultz)
     2. 07:28 AM - Re: brake lines with dual sticks (Bryan Martin)
     3. 08:01 AM - Commercial (George Race)
     4. 09:39 AM - Re: brake lines with dual sticks (Jonathan@Entry.co.za)
 
 
 


Message 1


  • INDEX
  • Back to Main INDEX
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 06:18:17 AM PST US
    Subject: Re: brake lines with dual sticks
    From: "James E. Schultz" <its4jes@aim.com>
    Chris I just did it and came in just behind the main gear, under the seat and thr u the large hole in the center spar structure. You have to install u-shaped brackets on the floor and tie the other end t o the fuel sediment bowl or add another u-bracket at that point to keep the lines at the lowest position to avoid the rest of the dual stick mechanisms. Lots of luck. JES -----Original Message----- From: chris Sinfield <chris_sinfield@yahoo.com.au> Sent: Sat, May 28, 2011 3:26 pm Subject: Zenith601-List: brake lines with dual sticks o.com.au> Can someone shoot me a/ some photos of how they put the plastic brake line s through the wing spar cut out/channel with duel sticks fitted?? There is not much room and I was thinking of running them below the rudder cables through the plastic. or any other Ideas.. I don't want to go outside the fuse and under the spar that way.. chris.. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=341306#341306


    Message 2


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 07:28:40 AM PST US
    From: Bryan Martin <bryanmmartin@comcast.net>
    Subject: Re: brake lines with dual sticks
    I ran mine through the rudder cable tunnel and out behind the main gear spring. On May 28, 2011, at 6:23 PM, chris Sinfield wrote: > > Can someone shoot me a/ some photos of how they put the plastic brake lines through the wing spar cut out/channel with duel sticks fitted?? > > There is not much room and I was thinking of running them below the rudder cables through the plastic. > > or any other Ideas.. I don't want to go outside the fuse and under the spar that way.. > > chris.. > > -- Bryan Martin N61BM, CH 601 XL, RAM Subaru, Stratus re-drive. do not archive.


    Message 3


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 08:01:18 AM PST US
    From: "George Race" <mykitairplane@mrrace.com>
    Subject: Commercial
    Hi gang, hope your building projects are moving right along now that summer has finally arrived. Just a gentle reminder that I build a lot of very nice custom parts for Zenith home builders. Check them out here: http://www.mrrace.com/Products/ Wishing you tail winds and fair skies, George Do not archive


    Message 4


  • INDEX
  • Back to Main INDEX
  • PREVIOUS
  • Skip to PREVIOUS Message
  • NEXT
  • Skip to NEXT Message
  • LIST
  • Reply to LIST Regarding this Message
  • SENDER
  • Reply to SENDER Regarding this Message
    Time: 09:39:49 AM PST US
    From: "Jonathan@Entry.co.za" <jonathan@entry.co.za>
    Subject: Re: brake lines with dual sticks
    I took mine straight down thru the floor, and down the middle channel, and along the underside of the undercarriage. Tapped into the undercarriage, and made small alluminium saddles to hold the pipes in place. Has worked fine for 300hrs Jonathan ----- Original Message ----- From: "Bryan Martin" <bryanmmartin@comcast.net> Sent: Sunday, May 29, 2011 7:25 AM Subject: Re: Zenith601-List: brake lines with dual sticks > <bryanmmartin@comcast.net> > > I ran mine through the rudder cable tunnel and out behind the main gear > spring. > > On May 28, 2011, at 6:23 PM, chris Sinfield wrote: > >> <chris_sinfield@yahoo.com.au> >> >> Can someone shoot me a/ some photos of how they put the plastic brake >> lines through the wing spar cut out/channel with duel sticks fitted?? >> >> There is not much room and I was thinking of running them below the >> rudder cables through the plastic. >> >> or any other Ideas.. I don't want to go outside the fuse and under the >> spar that way.. >> >> chris.. >> >> > > > -- > Bryan Martin > N61BM, CH 601 XL, > RAM Subaru, Stratus re-drive. > do not archive. > > > ----- > No virus found in this message. > Checked by AVG - www.avg.com >




    Other Matronics Email List Services

  • Post A New Message
  •   zenith601-list@matronics.com
  • UN/SUBSCRIBE
  •   http://www.matronics.com/subscription
  • List FAQ
  •   http://www.matronics.com/FAQ/Zenith601-List.htm
  • Web Forum Interface To Lists
  •   http://forums.matronics.com
  • Matronics List Wiki
  •   http://wiki.matronics.com
  • 7-Day List Browse
  •   http://www.matronics.com/browse/zenith601-list
  • Browse Zenith601-List Digests
  •   http://www.matronics.com/digest/zenith601-list
  • Browse Other Lists
  •   http://www.matronics.com/browse
  • Live Online Chat!
  •   http://www.matronics.com/chat
  • Archive Downloading
  •   http://www.matronics.com/archives
  • Photo Share
  •   http://www.matronics.com/photoshare
  • Other Email Lists
  •   http://www.matronics.com/emaillists
  • Contributions
  •   http://www.matronics.com/contribution

    These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.

    -- Please support this service by making your Contribution today! --