Today's Message Index:
----------------------
1. 12:36 PM - Re: Flap Switch (smgores)
2. 01:40 PM - Re: Re: Flap Switch (Steve T)
3. 06:14 PM - Re: Spar Cutout Help! (Tim Juhl)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Tim,
Bob Nuckolls shows how to make your own flap switch handle.In the 2nd picture he
mentions aluminum but I think he meant a type of plastic for the handle.
See the 8,9,10 and 11 pics down,starting with FLAPS1.JPG
http://www.aeroelectric.com/Pictures/Switches/
Mike
Rochester,mi.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=398077#398077
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I don't think the post worked yesterday, but we make flap handles out of aluminum
and powdercoat them. We have sold very many and received lots f positive feedback.
Steve
www.aircraftspecialty.com
Sent from my iPhone
On Apr 7, 2013, at 14:35, "smgores" <smgores@netzero.net> wrote:
>
> Tim,
> Bob Nuckolls shows how to make your own flap switch handle.In the 2nd picture
he mentions aluminum but I think he meant a type of plastic for the handle.
> See the 8,9,10 and 11 pics down,starting with FLAPS1.JPG
>
> http://www.aeroelectric.com/Pictures/Switches/
>
> Mike
> Rochester,mi.
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=398077#398077
>
>
>
>
>
>
>
>
>
>
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Spar Cutout Help! |
My skin didn't have the spar cutout although the factory marked the location to
cut. The skin did have the holes drilled but in some areas they were not a great
match. This was especially true on the bottom edge of the skin behind the
gear channel.
I wouldn't worry too much if the cutout is off slightly. You can trim it to fit
better if you like. My spar was closer to the rear predrilled rivet line so
I decided to make new ones. The wing will cover the unused holes by the spar and
the "T" shaped gusset that comes with the upgrade kit will cover the rest.
Good luck!
Tim
--------
______________
CFII
Champ L16A flying
Zodiac XL - Jabiru 3300A
Wing modifications done - back working on the fuselage
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=398109#398109
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|