Today's Message Index:
----------------------
1. 05:36 AM - Re: Going through someone else's work on an HDS (Carlos Sa)
2. 07:22 AM - Re: Going through someone else's work on an HDS (Jerry)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Going through someone else's work on an HDS |
Hello
I don't have the plans handy, but here are a couple of 601 websites that
can be helpful:
http://mthobby.pcperfect.com/ch601/index.htm
http://www.macsmachine.com/
Good luck
Carlos
CH601-HD, plans
On 14 October 2013 23:41, LNelson <lk.nelson@juno.com> wrote:
>
> I am trying to get some information on the location of the aleron horn. I
> purchased a "90%" complete kit. And the aleron horn contacts splice plate
> just past the rear zee. Is this the correct location. Also any pics of
> the cut outs for the ib/ob wing sections would be appreciated.
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Going through someone else's work on an HDS |
On 10/14/2013 8:41 PM, LNelson wrote:
>
> I am trying to get some information on the location of the aleron horn. I purchased
a "90%" complete kit. And the aleron horn contacts splice plate just past
the rear zee. Is this the correct location. Also any pics of the cut outs
for the ib/ob wing sections would be appreciated.
>
>
Larry,
I think you are talking about 6-V-7-7. There is a note on the plans that state
to "trim then to clear aileron control horn" so that you get the proper travel
on the aileron. I've attached 2 photos where you can see that I've removed
some metal to allow the spec'ed aileron throw.
Jerry Latimer
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|