Today's Message Index:
----------------------
1. 02:40 AM - Re: CO (SIDESLIP)
2. 01:47 PM - Nose gear (SUE JANNAKOS)
3. 01:50 PM - Nose gear bottom bearing (SUE JANNAKOS)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Bobby;
If it is a slip joint, you have two options. Use NICKEL Anti-Seize, or get Permatex
Copper RTV. The local snowmobile race shop here sees unbelievable EGT's and
told me the proper way to use this copper RTV silicone.
Coat each end with a VERY thin layer of Copper RTV Silicone, let it set up overnight,
or longer, then reassemble the parts. He has NEVER had a leak and runs
EGTS so high it would scare you! He melts pistons! The exhaust still doesn't leak.
Runs 150 shots of nitrous on a 2 cyl sled engine. These guys are making obscene
power and using this method, their exhaust doesn't leak!
I have a brand new exhaust, and just used the Nickel Anti seize and no leaks. Here
is what I've been told where everyone goes wrong. They assemble the exhaust
systems without ANY sort of lubrication at these joints, and in very short time
they wear out, and or seize, causing the exhaust to crack. Once a year I am
going to disassemble my exhaust and clean up the slip joints and coat them with
a new batch of Nickel anti seize. This stuff is designed for 1500 degrees
and up. The copper anti size used on brakes on your car isn't good enough.
Hope this helps!!
Chad
--------
C-GYXQ. 912ULS. 601XL-B
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=422720#422720
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I need to replace the nose gear bungee cord on my 601 HDS N4399, SN 6-4211
My question is:
6-G-2-1 Nose gear bottom bearing for 601-XL
6-F-10-1 Nose gear stop for 601-HD/HDS
Can I replace the 6-F-10-1 nose gear stop with the 6-G-2-1 Nose gear bottom
bearing?
Is sowhat is the cost of the nose gear bottom bearing?
=C2-
thanks,
Greg Jannakos
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Nose gear bottom bearing |
Looking for help with my nose gear and replacing the bungee cord.
6-G-2-1 Nose gear bottom bearing for 601-XL
6-F-10-1 Nose gear stop for 601-HD/HDS
Can I replace the 6-F-10-1 nose gear stop with the 6-G-2-1 Nose gear bottom bearing?
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|