Today's Message Index:
----------------------
1. 08:30 AM - Re: Wing Attach Bolts (Bryan Martin)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Wing Attach Bolts |
One possible guess =94 The bolts should be a tight fit in the
holes. On mine, I had to drive the bolts in with light taps with a
hammer. If the bolts fit too easily in the holes, there could be a small
amount of motion at the joint. This motion could cause the washers to
wear into the spar surfaces slightly. That would result in a slight loss
of tension load in the bolt and the apparent loss of torque.
--
Bryan Martin
N61BM, CH 601 XL,
RAM Subaru, Stratus re-drive.
do not archive.
> On Apr 26, 2017, at 8:30 PM, BobbyPaulk@comcast.net wrote:
>
> Paul,
> The nuts have not backed off.
> I had the paint dobs to make sure that they did not move.
> I don't know what is happening except maybe the metal is bending.
> Thanks for your input.
>
>
> Bobby
>
> Do Not Archive
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|