Today's Message Index:
----------------------
1. 10:04 AM - Re: Riveting the stab (pilot4pay)
2. 12:42 PM - Re: Riveting the stab (super58d)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Riveting the stab |
You will want a 3x gun. I bought a "budget" gun off e-bay, and wouldn't recommend
it. ATS has a nicely priced economy gun, No 2602A @$106, and that is what I'll
probably buy later on for the next solid rivet phase.
As far as suggestions, it's what you are comfortable doing. I couldn't comment
on structural issues, as I'm not an engineer. CH has given you the option to go
either way, so I'm sure he has done the math.
--------
Craig Smith
CH640 builder
SN: 0078
"Just think how stupid the average person is,
and then realize that half of them are even stupider!"
--George Carlin
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 6775#206775
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Riveting the stab |
Thanks Craig,
I have never driven rivets, so I guess I'll just have to practice. I am planning
on heading up to the plant this week or next to pick up the rest of the tail
kit. I am going to see if I can watch them drive some on an aircraft being worked
on, maybe they'll even give me a short block of instruction on how to do
it. Thanks for the insight and help.
Mark
--------
Mark
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p 6799#206799
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|