Today's Message Index:
----------------------
1. 06:25 AM - Re: leading edge bends? (pilot4pay)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: leading edge bends? |
I see there are several methods for the process, I guess I need to be more specific
in the question.
Carlos used a 2-3/8 pvc pipe, which is 60mm roughly, for a 53mm finished radius.
Please e-mail th pic to me, address is listed on post.
Ron used the flat press method with 58mm stop block, for the same LE radius?
I see the process at 601.org, 58mm stop block for 53mm radius, on the 601.
I don't have my notes in front of me with my template dimension for the tank LE
radius, but the trend is a stop block or pipe 5 to 7mm larger than desired radius?
I guess that's the little detail I'm looking for.
--------
Craig Smith
CH640 builder
SN: 0078
"Just think how stupid the average person is,
and then realize that half of them are even stupider!"
--George Carlin
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=223320#223320
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|