---------------------------------------------------------- Zenith640-List Digest Archive --- Total Messages Posted Fri 09/18/09: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:18 AM - Re: Phase 1 Flight Report (steveadams) 2. 01:32 PM - Dimensioning Question (Scott Stewart) 3. 11:01 PM - Re: Dimensioning Question (Scott Stewart) ________________________________ Message 1 _____________________________________ Time: 06:18:41 AM PST US Subject: Zenith640-List: Re: Phase 1 Flight Report From: "steveadams" Congratulations, I was wondering how the first flights went. Have fun and be careful. Steve Read this topic online here: http://forums.matronics.com/viewtopic.php?p=263664#263664 ________________________________ Message 2 _____________________________________ Time: 01:32:26 PM PST US Subject: Zenith640-List: Dimensioning Question From: "Scott Stewart" Hi All, I am trying to position the F4-3 horizontal tail attach plates. On page F4 of the plans, it shows a vertical dimension of 150 mm from the centerline of the rivets into the upper longeron to the centerline of the F4-3 horizontal tail attach plate. Yet this puts the attach plate low in the opening between the upper and lower rear side skins. To center the attach plate in this opening, this dimension should be closer to 135 mm. I have found a couple of places in my new computer-generated plans where the dimensions were typed incorrectly during the transition, and I am concerned this is another case. Could someone help confirm the vertical dimension to use for positioning the plates? Thanks! -------- Scott Stewart s/n: 0092 Building from plans Rudder and Stabilator complete. Wings at 65%. Fuselage at 40%. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=263730#263730 ________________________________ Message 3 _____________________________________ Time: 11:01:20 PM PST US Subject: Zenith640-List: Re: Dimensioning Question From: "Scott Stewart" Please disregard the last question. I calculated the correct distance to be 143 mm from the top of the upper longerons based on the required stabilator deflections shown on page M50 and the position of the F27 stops. -------- Scott Stewart s/n: 0092 Building from plans Rudder and Stabilator complete. Wings at 65%. Fuselage at 40%. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=263793#263793 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message zenith640-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith640-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/zenith640-list Browse Digests http://www.matronics.com/digest/zenith640-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.