Today's Message Index:
----------------------
1. 11:54 AM - Rear seat belt attachment clarification (Scott Stewart)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Rear seat belt attachment clarification |
Hi folks.
I need a little clarification on the rear seat plans. From what I can tell, the
rear seat is set up for lap belts only. So four seat belt attachment points
are needed. The plans call for fabricating four F40-11 attachments, but only
show where two are installed in the center of the seat. The rear seat IPL says
that the other two F40-11 attachments are to be installed at the sides of the
seat through the rear of the seat and the rear spar uprights, but this is obviously
incorrect since the rear of the seat is behind the uprights. The plans
also call for fabricating two F42-4 rear seat belt attachment plates which
get riveted to the side skins.
So what are the correct outside belt attachments to use? And what is the correct
method to mount them? Am I supposed to go back into my aircraft design mode
again to solve this?
Thanks.
--------
Scott Stewart
s/n: 0092
Building from plans
Rudder and Stabilator complete. Wings at 75%. Fuselage at 60%.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=306348#306348
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|