---------------------------------------------------------- Zenith640-List Digest Archive --- Total Messages Posted Tue 07/27/10: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 08:01 PM - Re: Rear seat belt attachment clarification (Doug Geese) ________________________________ Message 1 _____________________________________ Time: 08:01:17 PM PST US From: Doug Geese Subject: RE: Zenith640-List: Rear seat belt attachment clarification Scott, The rear seats do in fact have 3 point attachment (shoulder belts). The upper attach point is a bracket that rivets between the turtledeck skin and the baggage bulkhead. I'm at Oshkosh right now so I can't be certain as to wear the outer lower attach points are. I believe that your are correct, the rear spar uprights are actually the front of the rear seat. When I get home I can take a closer look and send some pics if you would like. Doug -----Original Message----- From: owner-zenith640-list-server@matronics.com [mailto:owner-zenith640-list-server@matronics.com] On Behalf Of Scott Stewart Sent: Monday, July 26, 2010 2:54 PM Subject: Zenith640-List: Rear seat belt attachment clarification Hi folks. I need a little clarification on the rear seat plans. From what I can tell, the rear seat is set up for lap belts only. So four seat belt attachment points are needed. The plans call for fabricating four F40-11 attachments, but only show where two are installed in the center of the seat. The rear seat IPL says that the other two F40-11 attachments are to be installed at the sides of the seat through the rear of the seat and the rear spar uprights, but this is obviously incorrect since the rear of the seat is behind the uprights. The plans also call for fabricating two F42-4 rear seat belt attachment plates which get riveted to the side skins. So what are the correct outside belt attachments to use? And what is the correct method to mount them? Am I supposed to go back into my aircraft design mode again to solve this? Thanks. -------- Scott Stewart s/n: 0092 Building from plans Rudder and Stabilator complete. Wings at 75%. Fuselage at 60%. Read this topic online here: http://forums.matronics.com/viewtopic.php?p=306348#306348 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message zenith640-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith640-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/zenith640-list Browse Digests http://www.matronics.com/digest/zenith640-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.