Today's Message Index:
----------------------
1. 04:09 PM - Re: CAD disk and new Photos (super58d)
2. 04:15 PM - Re: Skinning the Stab (super58d)
3. 05:53 PM - Re: CAD disk and new Photos (pilot4pay)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: CAD disk and new Photos |
Hey all,
I recently received the CAD disk and brand new plans to go along with them. I was
home on leave and only had time to browse through the plans, but I did note
some areas they had highlighted for special attention to be paid to. I haven't
noticed yet if any of the drawings have been updated in them. The disk works
fine too. It seems to use Firefox (Internet Explorer if you use that I guess)
as the medium for displaying all the photos and presentations. It doesn't go
on the internet, all the info is on the disk. There are a TON of pics and quite
a few .pdf docs that will come in very handy during the build. They did a decent
job of breaking the info down into folders separating the major sections
(rudder, stabilator, wings, fuselage, etc.). I would recommend spending the $150
to anyone who is less than halfway through the build.
--------
Mark
s/n 094
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=308293#308293
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Skinning the Stab |
Craig, I had the same questions and took a middle of the road approach to the issue.
I riveted about half way up the rear skins on both sides. This held the
entire assembly together much better and helped keep it straight and true while
drawing in the forward skins. It then still allowed me to lift the forward sections
to debur the new holes from the nose skins. I found that ensuring the
whole assembly stayed straight and true while keeping everything together was
quite difficult while applying pressure to pull in the nose skins.
--------
Mark
s/n 094
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=308294#308294
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: CAD disk and new Photos |
Did you get any errors opening any files? What operating system are you using,
and what version of Adobe acrobat reader are you running please?
C. Smith
--------
Craig Smith
CH640 builder
SN: 0078
"Just think how stupid the average person is,
and then realize that half of them are even stupider!"
--George Carlin
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=308304#308304
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|