Today's Message Index:
----------------------
1. 06:06 AM - Re: slats / flaps (carl)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: slats / flaps |
Ben
I built a second set of wings and using same flaps was no problem.
Just take accurate measurements from your flaps/slats for wing bracket
spacings and you will be ok. Do not trim inboard flaps until you fit wings
to fuselage.
Carl
----- Original Message -----
From: "bcchurch" <bcchurch@yahoo.com>
Sent: Monday, December 15, 2008 9:07 PM
Subject: Zenith701801-List: slats / flaps
>
>> Has anyone else built flaps prior to wings? If so, how well did things
>> work out for you? For those that built wings before flaps - did you use
>> the flap attach brackets from the manual or as measured from your wing?
>
> Same questions for slats.
>
> Maybe I should start working on the rear fuse...
>
> Any advice would be appreciated.
>
> Regards,
> Ben
>
> --------
> Ben Church
> CH801
> Racine, WI
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=219530#219530
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|