Zenith701801-List Digest Archive
Fri 06/26/09 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 04:09 PM - Re: 701 Fuel cap (Dan Wilde)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 04:09:03 PM PST US
From: Dan Wilde <dwilde@clearwire.net>
Subject: Re: 701 Fuel cap
Mike Hoffman wrote:
>
> Since the recent discussion about fuel caps, I looked at my plans and
> it does say to open up the 1/16 inch vent hole to 1/8 inch. Has anyone
> done this and would you explain the procedure?
>
>
>
> Also while looking at fuel caps, I see Aircraft Spruce has a vented
> cap (05-03459) with a hole drilled on the outside (I assume the hole
> faces forward for ram pressure) that looks very similar to ours. Has
> anyone modified their cap in this way or is there a problem with doing
> this?
>
>
>
> Thanks
>
> Mike Hoffman
>
I totally missed this on the plans but I have not had any problems with
fuel flow in over 70 hours. That being said, I went out and drilled the
hole per the plans.
Dan Wilde
N948DW
Other Matronics Email List Services
Post A New Message zenith701801-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith701801-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/zenith701801-list Browse Zenith701801-List Digests http://www.matronics.com/digest/zenith701801-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.