Today's Message Index:
----------------------
1. 08:56 AM - Rotec... TBI - 40 Mechanical Fuel Injection (R.D.(Ron) Leclerc)
2. 02:14 PM - Rudder Skin Question (Jake Crause)
3. 02:46 PM - Re: Rudder Skin Question (Phil Owens)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rotec... TBI - 40 Mechanical Fuel Injection |
Check out this new system by Rotec... TBI - 40 Mechanical Fuel Injection!
Designed for engines 80hp to 160hp...
http://www.rotecradialengines.com/TBI/TBI.htm#Price
First introduced at Oshkosh... very interesting and priced right, pretty
reasonable...
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rudder Skin Question |
Hey folks,=0A=0AI've got two questions concerning-801 rear rudder skin.
- Each question has a photo to go with it.=0A=0AQuestion 1:- If you not
ice from the photo, the edge of the very-forward bottom corner of the ski
n appears to be uneven.- What I mean is that when the skin was cut out at
the factory it appears there was not enough material in the sheet it was c
ut from to make the skin?- It looks like it-runs out of sheet at the bo
ttom.- Is this normal?- =0A=0AQuestion 2:- The bottom of-my rudder
skin was cut by the builder assist facility I took delivery of the tail kit
from.- Looking at photo two, the very-rear edge near the fold was not
cut straight but in an upward fashion.- The builder manual says cut along
the pre-marked line but since it was already cut I don't know where that l
ine was laid out.- Is this right?=0A=0AThanks guys. -I look forward to
hearing from you.=0A=0AJake Crause=0APooler, GA=0A=0A=0A
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Rudder Skin Question |
------------Boundary-00=_INTFQ7B2QL8000000000--
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|