Today's Message Index:
----------------------
1. 07:20 AM - Re: Fitting wings to fuse (Tony Bonsell)
2. 08:47 AM - Re: Re: Fitting wings to fuse (Curt Thompson)
3. 07:16 PM - Re: Fitting wings to fuse (joe motis)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Fitting wings to fuse |
Yeah I just put my wings on.
In the end I had a water level on the fuse, a water level from wingtip
to wing tip, two tape measures from wingtips to tail, a string from
wingtip to wingtip for the 75mm, horizontal laser level for fuse and
tail and a digital level for incidence. No bubble levels.
It took a long long time.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Fitting wings to fuse |
I found some info in the list archive that indicates that the incidence
angle should be zero. One builder indicated that he have to lower the front
of the horizontal stab by 1/2 inch.
It took most of the day but I got the wings and horizontal stab mounted. My
water level came in real handy.
Curt
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Fitting wings to fuse |
> I am having a bit of trouble making the nose ribs on the form block. Using
> the vise grip fluting tool from Spruce but maybe the 3/8 rod tool shown in
> the prints would work better. Any helpful hints?
Joe Motis
750 plans and Pietenpol assistant
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|