Today's Message Index:
----------------------
0. 12:16 AM - Just A Few Days Left; Still Trailing Last Year... (Matt Dralle)
1. 03:58 PM - muffler (sam hord)
2. 07:08 PM - replacing dry-rotted rubber grommets (ejessee)
3. 09:12 PM - Re: replacing dry-rotted rubber grommets (dennkrumm@aol.com)
Message 0
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Just A Few Days Left; Still Trailing Last Year... |
Dear Listers,
There are just a few more days left of this year's List Fund Raiser! Response
has been very good, but still well behind last year. If you've been waiting until
the last minute to make your contribution and maybe even pick up a great
gift, now might be good time to show your support!
Please remember that there isn't any sort of commercial advertising on the Lists
and the *only* means of keeping these Lists running is through your Contributions
during this Fund Raiser.
Please make a Contribution today!
http://www.matronics.com/contribution
Thank you!
Matt Dralle
Matronics Email List Administrator
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Is there anyone using a SuperTrapp on their 701? If so which one are you
using? I'm looking at the 443-2010, which is 4" dia x 8" long.
Sam
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | replacing dry-rotted rubber grommets |
Hello again,
The builder of my plane used rubber grommet to protect wires and tubing passing
through sheet aluminum. In a couple of places, these are dry-rotted and need
to be replaced.
Does anyone have any experience with some sort of split grommet which would prevent
my having to re-wire?
--------
Ernest Jessee
N4931M
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=274050#274050
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: replacing dry-rotted rubber grommets |
Yes- Take a normal rubber grommet, cut a slice clear through one edge wit
h an razor blade creating your slit. Install the grommet and rotate it so
the slit is either straight up, or 180 degrees away from where the wire
might have tension on the grommet. I have done this for years and is sti
ll working fine with no problems. The wire does not try to go into the sl
it. It is better to use the thicker of the two types of rubber grommets.
Dennis Krummel N801DK
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|