Zenith701801-List Digest Archive
Sat 11/21/09 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 08:41 AM - Re: Grommet replacement (Zed Smith)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 08:41:45 AM PST US
From: Zed Smith <zsmith3rd@earthlink.net>
Subject: Re: Grommet replacement
Simply cut the new grommet with a razor blade, knife, etc, and roll it into the
hole.
Success will depend somewhat on hole size & size of the wire bundle in said hole.
Another approach is to use a short piece of hose, couple of inches long, slit it
down one side (lengthwise) fit it around the wires, slide into hole. Put a nylon
Ty-Rap around each end to prevent it sliding any farther. One side ty-rap
if it is a blind hole, just secure that tie to the bulkhead.
Remember.....a grommet is nothing more than a very short piece of hose designed
to prevent chafing.
Regards,
Zed/701/R912/90+%/etc
Other Matronics Email List Services
Post A New Message zenith701801-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith701801-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/zenith701801-list Browse Zenith701801-List Digests http://www.matronics.com/digest/zenith701801-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.