Today's Message Index:
----------------------
1. 10:12 PM - Rudder cables - Again (philip smith)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rudder cables - Again |
OK guys ,
What method did you use to route the rudder cables through the side of the
fuselage? If I stretch the cable from the rudder to the fair lead in the
fuselage there is interference in the cable and the fuselage side - can't
remember the "nylon" part number, but the print shows that you cut a 1/8th
slot to 15 mm from the end then pass the cable thru this slot. If I do this
the cable will rub on the fwd part of the hole in the AL. I've tried
several ideas up to trying to fabricate a fair lead from a tube of nylon but
just can't seem to get what I want. The other option is that I make the
slot in the "nylon" material - say 15mm long or so - just long enough to
keep the cable from rubbing on the fuselage side skin fwd and aft..
Everyone's ideas are more than welcome. I'd like some rapid response as as
I plan to route the cables - right or wrong - tomorrow. Hopfully some one
with the correct idea will read this and send me some ideas and pictures.
As usual thanks for your help -,getting back off line would be fine with me
madriver@wildblue.net
Phil
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|