Today's Message Index:
----------------------
1. 07:38 PM - Machining rivet gun heads (Perry Delano)
2. 07:52 PM - Re: Re: Tail feather open spaces (Gordon)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Machining rivet gun heads |
I'm anxious to rivet my rudder skeleton together, is there a good way to do
this at home without any exotic bits or tools. If not, I'll send them to
Zenith.
Also, is Zinc-Chromate still the rust inhibitor of choice.
Finally, I do not want to wear Joyce out at Zenith, so I'll ask the question
here. I was originally going to build from plans but due to time contraints
realize a kit is the only way to go.
Where on the Zenith site or Builders site do I find where to buy the updated
construction manual CD. Joyce tells me its there but I have not been able to
find it.
With the changes that have been made to the kit since I bought my plans I've
found that although I avoided any mistakes in putting the rudder skeleton
together
there was the potential to do something wrong given the predrilling
in the new kit parts.
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Tail feather open spaces |
I had a similar experience attempting full power stalls -- I think torque
exceeds the control surface force. I have never been able to get the plane
to do anything but a benign mush with low power.
Gordon
----- Original Message -----
From: "dashwood" <dashwoodlock@hotmail.com>
Sent: Saturday, April 30, 2011 2:11 AM
Subject: Zenith701801-List: Re: Tail feather open spaces
> <dashwoodlock@hotmail.com>
>
> be careful when pushing the stall . I was testing the stall at altitude
> the other day. was cycling a little throttle and trying to get as steep an
> angle of attack as i could. one last throttle burst and one last pull on
> the stick turned it a hammerhead stall and she flipped over backwards. not
> something i would recommend. reminded me i must clean the carpets more
> often.
>
> --------
> Ross Aalexander: CH701 driver 912ul 490tt
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=338505#338505
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|